top of page

UNLOADINGING FILAMENT

to Change the Color or Type

Art-Pro-Plus-Unload-Button_edited.jpg

To unload the filament double click the second button which is the unload button. You will notice that the motor will start to move the filament back out of the heating chamber and pen. It should automatically unload.

 

Once the filament releases you will need to push the unload button one more time so it will stop unloading. When the filament is loose it can be gently pulled out of the pen.

 

Be sure to cut the filament straight after you remove it for your next use. 

Note: Your 3D pen will automatically start to cool down after unloading so it is important that you push the + button and the load button at the same time to let the pen know you are still working.  

...another way to keep the pen heated is to press the load button ONE TIME so the pen will heat up again.

 

Once it is at target temperature, it is ready for you to load the filament. If after you unload the filament, you leave the pen idle for 2 minutes, it will cool all the way down and shut off. It does not take long for the pen to heat if this happens.

UNLOADINGING FILAMENT

& Shutting Down the Pen

New-Loading-Filament.jpg

When you are finished with the pen, it is important for you to unload it. To unload the filament double click the second button which is the unload button.

 

You will notice that the motor will start to move the filament back out of the heating chamber and pen. It should automatically unload.

 

Once the filament releases you will need to push the unload button one more time so it will stop unloading.

 

Once the filament is lose it can be gently pulled out of the pen. Be sure to cut the filament straight after you remove it for your next use.

 

The pen will start cooling down and will automatically shut down after 2 minutes of idle use. Then it can be unplugged from the power source and you are done until next time!

New-Pen-Shut-Down.jpg
bottom of page